Check Out NMA    Learn More About our Partnership
Close and Enjoy Drawabox Ad-free

250 Box Line Weight

9:34 PM, Monday November 9th 2020

Hi there,

I have a question in regards to the instruction for the 250 box challenge. In the instruction section titled "Line Weight", it is suggested to go back over lines that make up a box's silouette to reinforce the solidity of the box. Uncomfortable writes, "Basically, it means making certain lines thicker than others (by going back over them with a confident, planned stroke)."

I'm worried that by intending to go over lines I've already put down, the "reinforcing" lines I make may go off the original line and end up looking like I was trying to fix a line. Does this make sense, and is this acceptable?

Thanks!

Report
1 users agree
12:11 AM, Tuesday November 10th 2020

It's not that exact a science. If it isn't much off it's no big deal, if it's far off it would be obvious. Don't sweat it all, just try to improve on the next one.

12:27 AM, Sunday December 6th 2020

Thanks!

1 users agree
3:06 PM, Saturday November 14th 2020

Hey there!

When it comes to line weight, your concerns make perfect sense. Going over an entire line again to reinforce it is pretty nerve racking since it's so easy to mess up. Honestly, I'd say go for it, as you don't want to be scared of reinforcing your lines. It'll help you build confidence. As you reinforce your lines, you are definitely going to mess up, but it's alright to make mistakes as long as you focus on improving the next box.

Hope this helps you!

12:30 AM, Sunday December 6th 2020

Very helpful, thank you! I'm almost 10% into it now, and the reinforcing has been challenging and rewarding.

The recommendation below is an advertisement. Most of the links here are part of Amazon's affiliate program (unless otherwise stated), which helps support this website. It's also more than that - it's a hand-picked recommendation of something I've used myself. If you're interested, here is a full list.
Ellipse Master Template

Ellipse Master Template

This recommendation is really just for those of you who've reached lesson 6 and onwards.

I haven't found the actual brand you buy to matter much, so you may want to shop around. This one is a "master" template, which will give you a broad range of ellipse degrees and sizes (this one ranges between 0.25 inches and 1.5 inches), and is a good place to start. You may end up finding that this range limits the kinds of ellipses you draw, forcing you to work within those bounds, but it may still be worth it as full sets of ellipse guides can run you quite a bit more, simply due to the sizes and degrees that need to be covered.

No matter which brand of ellipse guide you decide to pick up, make sure they have little markings for the minor axes.

This website uses cookies. You can read more about what we do with them, read our privacy policy.